![]() I wish to flash the MGC3130's GestIC library with my PIC32MX (the host microcontroller).įirst of all i need to decode the content of the.ĭecoding GestICLibrary. ![]() I've found out that the file follow the Intel HEX file format: enc library file, to extract all the necessary data that must be written in the flash memory of the MGC3130. after that there are all the necessary Data Records with this format it starts with an Extended Linear Address Record (:020000040000FA). and finally it ends with an End-of-File (EOF) Record (:00000001FF). Smartcard Decoding Program Update Download Smartcard Decoding Program Updated-> LIBO RFID Smart Card Reader Writer NFC 13.56MHz Copier 125KHz Duplicator Programmer Multi-Frequency Decoding Software USB Support with Readable Rewritable RFID Keyfobs Tags 3.8 out of 5 stars 11 47.99 47. ![]() Let's exclude the first two data records because I'm quite sure that they are filled up with the Firmware version info (120bytes in the first data record) and the crypto IV key (14bytes in the second data record). On all the other data records, the first byte of available data looks like the a dataLength field, infact most of the records have a 0x80 value, means that the following bytes are 128, ready to be written in a complete memory page of the MGC3130 (128bytes/page). ![]() Its main functionalities are: Commands interpreter and script execution. It is use with the training that I give in some circumstances. My doubts are with some data records with less than 128bytes, they must be some incomplete memory pages i think. PCCAM is a software used to communicate with the smartcards (asynchronous). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |